Crestron CP3 Dokumentacja Pobierz pdf (Strona 15)

Crestron CP3 3-Series Control System™

Operations Guide – DOC. 7316A 3-Series Control System™: CP3 • 11

Installation

Ventilation

The CP3 should be used in a well-ventilated area. The venting holes should not be

obstructed under any circumstances.

To prevent overheating, do not operate this product in an area that exceeds the

environmental temperature range listed in the table of specifications. Consider using

forced air ventilation and/or incrementing the spacing between units to reduce

overheating. Consideration must be given if installed in a closed or multi-unit rack

assembly since the operating ambient temperature of the environment may be greater

than the room ambient temperature. Contact with thermal insulating materials should

be avoided on all sides of the unit.

Rack Mounting

The CP3 can be mounted in a rack or stacked with other equipment. Two “ears” are

provided with the CP3 so that the unit can be rack mounted. These ears must be

installed prior to mounting. Complete the following procedure to attach the ears to

the unit. The only tool required is a #1 or #2 Phillips screwdriver.

WARNING: To prevent bodily injury when mounting or servicing this unit in a

rack, take special precautions to ensure that the system remains stable. The following

guidelines are provided to ensure your safety:

• When mounting this unit in a partially filled rack, load the rack from the

bottom to the top with the heaviest component at the bottom of the rack.

• If the rack is provided with stabilizing devices, install the stabilizers before

mounting or servicing the unit in the rack.

NOTE: If rack mounting is not required, rubber feet are provided for tabletop

mounting or stacking. Apply the feet near the corner edges on the underside of the

unit.

NOTE: Reliable earthing of rack-mounted equipment should be maintained.

Particular attention should be given to supply connections other than direct

connections to the branch circuit (e.g. use of power strips).

To install the ears:

1. There are screws that secure each side of the CP3 top cover. Using a #1 or

#2 Phillips screwdriver, remove the three screws closest to the front panel

from one side of the unit. Refer to the diagram following step 3 for a

detailed view.

2. Position a rack ear so that its mounting holes align with the holes vacated

by the screws in step 1.

3. Secure the ear to the unit with three screws from step 1, as shown in the

following diagram.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Brak uwag

Crestron CP3 Dokumentacja Strona 15