Crestron CPC-2000A Dokumentacja Pobierz pdf (Strona 5)

Crestron CPC-CAMI Pan/Tilt Camera Head with Control Interface

Adjustable mounting plates (flat and angled) and mounting hardware are provided

with each CPC-CAMI. The two plates can be fixed to one of the rotating disks with

the mounting hardware to provide camera/lens support. The other disk serves as a

mounting platform for the CPC-CAMI with attached camera/lens assembly.

CPC-CAMI Ports

A number of ports are located on the CPC-CAMI interface box. Each has a silk-

screened label. Refer to the illustration and descriptions after this paragraph.

CPC-CAMI Inteface Box

NET

This 6-pin, 6-position RJ11 modular jack is used to connect the CPC-CAMI to the

control system.

NOTE: Before making connections to the NET port, review the latest revision of

the Network Modular Cable Requirements (Doc. 5682). Most 4-conductor phone

cables are wired in a crisscross fashion and are not compatible with Crestron

equipment. The wiring document can be obtained from the Downloads page

(CABLES and MANUALS Libraries) of the Crestron website (www.crestron.com)

Search for the MODULAR.PDF file.

LENS

This DB15 female connector provides three channels for zoom, focus, and iris, as

well as additional signals depending on lens. Refer to the pinout table below. A 15-

pin D-sub male connector with hood (P/N 748048-1) is supplied and attaches to the

LENS port. To properly wire this male connector, a wiring schematic for each lens

type (A through D) follows the pinout table. Crestron maintains a limited number of

cabling drawings for lenses. Refer to “Appendix: Application Examples” on page 19

for specific pan/tilt and lens applications. The information in the appendix offers

recommended cabling connections with the appropriate lens type.

Operations Guide - DOC. 5726A Pan/Tilt Camera Head with Control Interface: CPC-CAMI • 3

1 2 3 4 5 6 7 8 9 10 ... 23 24

Brak uwag

Crestron CPC-2000A Dokumentacja Strona 5