Crestron TPMC-V15 Przewodnik Instalacji Pobierz pdf (Strona 12)

Wall Mount Kits Crestron TPMC-V15-WALL, V15-WALL & WMKC-V15

Installation

This section provides assembly and installation procedures for the Wall Mount and

Chassis Wall Mount Kits. The “WMKC-V15 Procedure” starts below and the

“TPMC-V15-WALL and V15-WALL Procedure” starts on page 10. Be sure to

review each procedure before starting.

WMKC-V15 Procedure

This section provides the necessary steps for the assembly of a TPMC-V15

Integrated 15” Touchpanel or V15 V-Panel 15” Touchpanel Display into a wall

mount chassis. Review the procedure and complete the steps in the order provided.

The only tool required is a #2 Phillips screwdriver.

NOTE: If converting a TPMC-V15-TILT or V15-TILT, remove the plastic cover on

the back of the panel to expose the tilt arm mounting assembly. Then remove the

four screws that hold the tilt arm with a #2 Phillips screwdriver. Follow the

procedure below to mount the TPMC-V15 or V15 into the chassis wall mount kit.

1. Attach the symmetrical VESA mounting bracket (2023927) to the rear of

the touchpanel using the four included M4 x 12 mm screws (2023678).

Make sure that the stand offs are facing away from the rear of the

touchpanel. Do not over tighten screws.

2. Place the wall mount chassis (2023922) over the back of the touchpanel.

The large cutout in the chassis should align with the bottom of the

touchpanel. Align the screw holes and secure the touchpanel with the four

included #08-32 x 1/4” Phillips head screws (2007263). The finished

product is essentially the TPMC-V15-WALL or V15-WALL. Refer to the

illustration on the following page for visual guidance.

8 • Wall Mount Kits:TPMC-V15-WALL, V15-WALL & WMKC-V15 Installation Guide – DOC. 6884B

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Brak uwag

Crestron TPMC-V15 Przewodnik Instalacji Strona 12