Crestron DM-RX1-1G Instrukcja Użytkownika Pobierz pdf (Strona 4)

DM-RX1-4K-C-1G Wall Plate 4K DigitalMedia 8G+

Receiver

Crestron Electronics, Inc. 15 Volvo Drive

Rockleigh, NJ 07647

Tel: 800.237.2041 / 201.767.3400

Fax: 201.767.1903

www.crestron.com

All brand names, product names and trademarks are the property of their respective owners.

Speciﬁcations subject to change without notice. Revised 04/17/15

Notes:

1. The maximum cable length for DigitalMedia 8G+ (DM 8G+) or HDBaseT is dependent upon

the type of cable and resolution of the video signal. Refer to the “Maximum Cable Lengths”

table for a detailed overview. Crestron legacy cable models DM-CBL DigitalMedia Cable and

DM-CBL-D DigitalMedia D Cable support the same resolutions and cable lengths as CAT5e.

Shielded cable and connectors are recommended to safeguard against unpredictable

environmental electrical noise which may impact performance at resolutions above 1080p.

Refer to the Crestron DigitalMedia Design Guide, Doc. #4546 for complete system design

guidelines. DM 8G+ is compatible with HDBaseT Alliance specifications for connecting to

HDBaseT compliant equipment. All wire and cables are sold separately.

2. The DM-RX1-4K-C-1G does not include an Ethernet port. Local Ethernet connectivity for

external devices requires a MP-WP183 or equivalent Ethernet jack with a dedicated

LAN connection.

3. The HDMI output requires an appropriate adapter or interface cable to accommodate a DVI

signal. CBL-HD-DVI interface cables are available separately.

4. Receiving Power over DM (PoDM) or Power over HDBaseT (PoH) requires connection to a

switcher or other equipment that has a PoDM or PoH PSE (Power Sourcing Equipment) port.

Any wiring that is connected to a PoDM or PoH PSE port is for intra-building use only and

should not be connected to a line that runs outside of the building in which the PSE is located.

5. Supports simple pass-through of CEC when connected directly to a DM-TX1-4K-C-1G

transmitter. Supports full management of CEC between the locally connected HDMI device and

a control system when connected to any Ethernet-enabled DM transmitter or switcher that

supports CEC over HDBaseT. Refer to the spec sheet for each DM transmitter, switcher, output

card, or output blade to verify “CEC” is listed under “HDBaseT” in the “Communications”

section of the product’s specifications.

6. References to the IEEE 802.3af and 802.3at standards are used to demonstrate that PoDM

and PoH technology is similar in function to PoE and follows the same essential specifications.

The DM-RX1-4K-C-1G cannot be powered over Ethernet, and its DM IN port should not be

connected directly to an Ethernet network or device.

This product may be purchased from an authorized Crestron dealer. To find a dealer, please

contact the Crestron sales representative for your area. A list of sales representatives is available

online at www.crestron.com/salesreps or by calling 800-237-2041.

The specific patents that cover Crestron products are listed online at: patents.crestron.com.

Crestron, the Crestron logo, DigitalMedia, DigitalMedia 8G, DigitalMedia 8G+, DM, DM 8G, and

DM 8G+ are either trademarks or registered trademarks of Crestron Electronics, Inc. in the

United States and/or other countries. Dolby and Dolby Digital are either trademarks or registered

trademarks of Dolby Laboratories in the United States and/or other countries. DTS, DTS-HD, and

DTS-HD Master Audio are either trademarks or registered trademarks of DTS, Inc. in the United

States and/or other countries. HDBaseT and the HDBaseT Alliance logo are either trademarks or

registered trademarks of the HDBaseT Alliance in the United States and/or other countries. HDMI

and the HDMI Logo are either trademarks or registered trademarks of HDMI Licensing LLC in the

United States and/or other countries. Other trademarks, registered trademarks, and trade names

may be used in this document to refer to either the entities claiming the marks and names or their

products. Crestron disclaims any proprietary interest in the marks and names of others. Crestron

is not responsible for errors in typography or photography. Specifications are subject to change

1 2 3 4

DM-RX1-4K-C-1G 1
Receiver 1

Komentarze do niniejszej Instrukcji

Brak uwag

Crestron DM-RX1-1G Instrukcja Użytkownika Strona 4

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Odbiornik Crestron DM-RX1-1G