Crestron DM-RMC-200-S Instrukcja Użytkownika Pobierz pdf (Strona 5)

DM-RMC-200-S DigitalMedia 8G

™

Fiber Receiver & Room Controller 200

crestron.com

800.237.2041

Dimensions

Height: 7.92 in (202 mm)

Width: 10.83 in (275 mm) with mounting bracket

Depth: 1.73 in (44 mm) with mounting bracket

Weight

3.20 lb (1.45 kg) including bracket and power pack

MODELS & ACCESSORIES

Available Models

DM-RMC-200-S: DigitalMedia 8G

™

Fiber Receiver & Room Controller 200

Included Accessories

PW-2420RU: Power Pack, Desktop, 24VDC, 2A (50 Watts), Regulated, US/

International (Qty. 1 included)

Available Accessories

CRESFIBER8G-NP: CresFiber

8G Multimode Fiber Optic Cable, 50/125 x4

breakout, non-plenum

CRESFIBER8G-P: CresFiber

8G Multimode Fiber Optic Cable, 50/125 x4

breakout, plenum

CRESFIBER-CONN-SC50UM-12: Connectors for CresFiber

8g Multimode

Fiber Optic Cable, SC 50µm, 12-Pack

CRESFIBER-TK: CresFiber

Termination Kit (AFL Telecommunications

™

)

CRESFIBER-SINGLE-SC-P: CresFiber

Simplex Fiber Optic Cable

Assembly, 50/125, SC, Plenum

CBL Series: Crestron

Certified Interface Cables

MP-WP Series: Media Presentation Wall Plates

MPI-WP Series: Media Presentation Wall Plates - International Version

CNSP-XX: Custom Serial Interface Cable

IRP2: IR Emitter Probe w/Terminal Block Connector

USB-EXT-DM: USB over Ethernet Extender with Routing

Notes:

1. The maximum cable length for DigitalMedia 8G Fiber (DM 8G Fiber) is 1000 ft (300 m)

using Crestron CRESFIBER8G multimode fiber optic cable, or 500 ft (150 m) using Crestron

legacy CRESFIBER, Crestron CRESFIBER-SINGLE-SC, or third-party OM3 simplex multimode

fiber optic cable. Refer to the Crestron DigitalMedia Design Guide, Doc. #4546 for complete

system design guidelines. All wire and cables are sold separately.

2. The HDMI output requires an appropriate adapter or interface cable to accommodate a DVI

signal. CBL-HD-DVI interface cables are available separately.

3. Automatically passes 3D video if the display device supports it (reverts to pass-through mode

without scaling). Provides automatic 3D-to-2D conversion (with scaling) if the display device

does not support 3D. 3D with scaling is only supported using two DM-RMC-200-Ss configured

for use with a dual-projector 3D setup.

4. EDID (Extended Display Identification Data) is data embedded in an HDMI, DVI, or VGA signal

that enables a display device to tell the source device what resolutions and formats it can

support, allowing the source to configure itself automatically to feed the best signal that both

devices can support.

5. The analog stereo audio output (line-level and amplified) is only active when the

DM-RMC-200-S is receiving a 2-channel stereo signal.

6. USB-EXT-DM USB over Ethernet Extender Modules are sold separately. Refer to the

USB-EXT-DM spec sheet for more information.

7. Video wall processing requires a separate DM-RMC-200-S for each individual display.

8. With or without reduced blanking.

9. With reduced blanking only.

This product may be purchased from an authorized Crestron dealer. To find a dealer, please

contact the Crestron sales representative for your area. A list of sales representatives is available

online at www.crestron.com/salesreps or by calling 800-237-2041.

The specific patents that cover Crestron products are listed online at: patents.crestron.com.

Crestron, the Crestron logo, CresFiber, DigitalMedia, DigitalMedia 8G, DM, and DM 8G are either

trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or

other countries. Dolby and Dolby Digital are either trademarks or registered trademarks of Dolby

Laboratories in the United States and/or other countries. DTS, DTS-HD, and DTS-HD Master

Audio are either trademarks or registered trademarks of DTS, Inc. in the United States and/or

other countries. HDMI and the HDMI Logo are either trademarks or registered trademarks of

HDMI Licensing LLC in the United States and/or other countries. Other trademarks, registered

trademarks, and trade names may be used in this document to refer to either the entities claiming

the marks and names or their products. Crestron disclaims any proprietary interest in the marks

and names of others. Crestron is not responsible for errors in typography or photography.

1 2 3 4 5 6

Komentarze do niniejszej Instrukcji

Brak uwag

Crestron DM-RMC-200-S Instrukcja Użytkownika Strona 5

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Odbiornik Crestron DM-RMC-200-S