Crestron C2N-DAP8 Dokumentacja Pobierz pdf (Strona 29)

Crestron C2N-DAP8 Digital Audio Processor

Operations Guide – DOC. 8186 Digital Audio Processor: C2N-DAP8 • 25

Set up for communications as follows:

1. Initially, the Pass To check box is not selected indicating a direct

connection from your PC to the C2N-DAP8. Select Pass To if your PC and

the C2N-DAP8 are connected through the control system via Cresnet. Make

certain the Cresnet ID setting is correct (50 is the default for the C2N-

DAP8). Refer to “Identity Code” on page 10 for more information on

setting the Cresnet ID.

2. Click on the Connection Settings Viewport Settings button to display the

“Port Settings” window. Select RS-232 as the connection type. Verify that

an available COM port is selected, and that all communication parameters

and necessary options from the “Port Settings” window are selected as

shown in the illustration below. Click the OK button to save the settings

and close the window.

3. Synchronize communication between the PC and the device by clicking the

Transfer Configuration Load From Device button. This transfers any

current settings of the C2N-DAP8 to the DAT program.

NOTE: Before making any adjustments via the DAT program, immediately save the

program (use File | Save As) to preserve the current device settings. This is

especially important if you are working on a device that has already been configured

and you subsequently need to restore those settings.

“Port Settings” Window

Speaker Sizes / Bass Management

This screen lets you specify the room speaker arrangement, and set the crossover

frequency for the subwoofer.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 71 72

Brak uwag

Crestron C2N-DAP8 Dokumentacja Strona 29