Crestron infiNET Gateway C2N-MNETGW Dokumentacja Pobierz pdf (Strona 9)

infiNET™ DIMMERS

Appendix: Wiring Diagrams

Following are wiring diagrams for circuits that may be found when installing infiNET dimmers:

Stand-Alone Installations

Figure 1: Wiring a CLW-DIM(S)XRF (CLW-DIMS1RF shown)

• Since a -DIMSXRF is installed without a slave, the blue lead of the -DIMS1/4RF must be capped.

If a neutral is not present in the wallbox, the wiring shown in the following diagram can be used.

Figure 2: Alternative Wiring of -DIM1RF, -DIMS1RF, -DIM4RF, and -DIMS4RF Where Neutral is Not Present

(Load-Fed Switch Loop)

In the above configuration:

• The white wire from the DIMSXRF to the load is coded HOT.

• Since a -DIMSXRF is installed without a slave, the blue lead of the -DIMS1/4RF must be capped.

• The minimum load requirement is 100W.

• Bulb noise may be present even when the load is off.

• Circuits with small magnetic low-voltage loads may not work.

9 • infiNET™ Wall Box Dimmer : CLW-DIM1/4RF, DIMS1/4RF, & SLVD1RF Installation Guide – DOC. 6292C

1 2 3 4 5 6 7 8 9 10 11 12

Brak uwag

Crestron infiNET Gateway C2N-MNETGW Dokumentacja Strona 9