Crestron TPMC-10-DSW Instrukcja Użytkownika Pobierz pdf (Strona 6)

Mud Mount Kits Crestron MMK-8X-DSW & WMKM-8X-DSW

Installation

This section provides an installation procedure for each Mud Mount Kit. The

“MMK-8X-DSW Procedure” starts below and the “WMKM-8X-DSW Procedure”

starts on page 7. Be sure to review each procedure before starting.

MMK-8X-DSW Procedure

This section provides the necessary steps for the assembly of the MMK-8X-DSW

with either the BB-8X-DSW or PKM-8X-DSW. It is assumed that the BB-8X-DSW

or PKM-8X-DSW has been secured to the stud according to the instructions in the

latest revisions of their Installation Guides (Doc. 6579 and Doc. 6580 respectively).

It is also assumed that drywall is in place and a rectangular cutout for the

TPMC-8X-DSW is made in the drywall.

Complete the steps in the order provided. The only tools or materials required and

not supplied are four standard drywall screws, #2 Phillips screwdriver, a level and

tools/material to apply drywall joint compound.

CAUTION: Allow an air gap of at least 12 inches (30.48 cm) in the wall cavity

above and below the TPMC-8X-DSW for heat dissipation.

NOTE: The illustrations in this procedure show the installation of the

MMK-8X-DSW with the PMK-8X-DSW. Even though the illustrations only show

the PMK-8X-DSW, they are identical for the BB-8X-DSW.

1. Pass an adjustment plate through the opening and align its two center holes

with the top two pins on the PMK-8X-DSW. Verify that the pins on the

adjustment plate are not between (facing) the adjustment plate and the

PMK-8X-DSW. Refer to the illustration on the following page for visual

guidance.

4 • Mud Mount Kits: MMK-8X-DSW & WMKM-8X-DSW Installation Guide – DOC. 6581B

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Brak uwag

Crestron TPMC-10-DSW Instrukcja Użytkownika Strona 6